HARD RACING TecCel is an antifouling for boats with a wide speed range.
Particularly suitable for powerboats. Do not use on aluminium hulls or light alloy.
Risk of corrosion in case of direct contact. For cold water, warm and hot.
Colour: Red 56460
Volume solids,% 49 ± 1
Spreading rate: 12.3 m2/l [sq.ft./US gallon 493.2]-40 micron/1.6 mils
VOC content g/l 440 [3.6 lb/gallons USA]
Touche dry about 4 hour (s) 20° C/68° F approx 8. hour (s) 10° C/50° F
Specific gravity 1.6 kg/lt [13.2 lb/gallons USA]
Flash point° C 28 [82.4° F]
Application method:/Airless spray Brush/Roller/Cloth/spray paint
Thinner, (max volume) 08081 (5%)/(5%)/08081 08081 (5%)
nozzle hole-0.023 0.018 "
nozzle pressure 150 bar [2175 psi] (data for airless spray are indicatrivi and subject to adjustments)
Cleaning equipment HEMPEL's THINNER 08081
Dry thickness - recommended 40 micron [1.6 mils]
Wet thickness - recommended 75 micron [3 mils]
Overcoating interval, min as specified.
Overcoating interval, max as specified.
Existing self-polishing antifouling: remove any oil or grease, etc. with appropriate detergent (HEMPEL's PRE-CLEAN 67602) and clean with fresh water at high pressure to ensure the complete removal of any antifouling. Allow to dry before covering.
Hard matrix antifouling exists: Sand to remove the old layer.
Remove any oil or grease, etc. with appropriate detergent (HEMPEL's PRE-CLEAN 67602) and clean with fresh water at high pressure to ensure the complete removal of any antifouling. Allow to dry before covering.
Sealant: The use or not of a a coat of sealant/tie depends on the type and condition of existing antifouling.