Veneziani Wood Mat H2O Transparent Varnish Lt 1 #473COL216

Veneziani Wood Mat H2O Transparent Varnish Lt 1 #473COL216

Veneziani Wood Mat H2O Transparent Varnish Lt 1 #473COL216

Bi-component, polyurethane topcoat. Wood mat H2O is based on water, satin- finish, transparent and non-yellowing. High resistance to marine environment. It is particularly suitable for the treatment of bulkheads, furniture and all internal wooden surfaces
Price:
€60.66
Listing:
€71.36
You Save:
€10.70 (15%)

Description

Veneziani Wood Mat H2O Transparent Varnish Lt 1

Bi-component, polyurethane topcoat. Wood mat H2O is based on water, satin- finish, transparent and non-yellowing. High resistance to marine environment. It is particularly suitable for the treatment of bulkheads, furniture and all internal wooden surfaces. Excellent expansion and abrasion resistance. Ready to use and easy to apply. Not suitable for substrates subject to continuous immersion. This product is excellent for wooden floors and pots.

Product information
Finish Matt
Colour Transparent
Solids (by volume) ASTM D2369          42 ± 2%
Specific gravity UNI EN ISO 2811-1     1,04 ± 0,05 g/cm3
Flash Point UNI EN ISO 13736
VOC (calculated average content) ISO 11890-2/2006     22 g/l
Packaging 1 Lt

Application and use
SURFACE PREPARATION
New wood or renewed: The support must be dry and the moisture of the wood must not exceed 18%.
All surfaces to be painted must be clean, dry and free of contaminants. Sand down with P80-P120 abrasive paper. Before proceeding with the application of the products, blow with clean and dry air, to remove any residue of sanding and dirt. Apply, as a primer, a coat of FIBRODUR, and after apply the first coats of WOOD MATT H2O. Proceed with the following coats (3-5 coats) in the same way.

Wood already varnished: sand to remove traces of varnish during stripping or to level the surface; apply the first coats of WOOD MATT H2O (2-4 coats) in the same way.

N.B. Between one coat and the following abrade with Scotch Brite fine (grey)

High resistance cycle: on new or bare wood apply two coats of Resina 2000, sand down between one coat and the other

CONDITIONS DURING APPLICATION
In order to avoid the formation of condensation, the temperature of the surface should be at least 3 °C above dew point. During the application and curing the min. ambient temperature must not be lower than 15 °C or higher than 30 °C; substrate temperature must not be lower than 10 °C, since curing is remarkably reduced at lower temperatures. Application is not advisable when relative humidity exceeds 75%. The termhygrometric
survey should be carried out near the surface to be coated. Make sure there is enough
ventilation when the application takes place in closed areas.

Recommended thinner 5780, our code 473COL252.

Unit size 1 lt.
Transparent varnish.

Accessories

  1. 1
    Veneziani Thinner 6780 - 0,5Lt #473COL252
    Listing:
    €14.14
    Price:
    €12.02
    You Save:
    €2.12 (15%)
    Thinner 6780 for polyurethane paints. Suitable for thinning Adherglass, Fibrodur, Polyrex Pro, Wood Gloss, Wood Mat, Superverex Antiskid.