FIBERGLASS PUTTY is a universal, ice-white, thixotropic polyester putty with a spatula, with very refined fillers and excellent adhesion. Suitable for filling missing parts on metal, hot-dip or galvanized sheets, aluminium, steel, fibreglass, etc. Its excellent qualities mean that the product can be troweled and easily sanded, making it absolutely unparalleled in restoration work. Also available in the LIGHT FIBERGLASS STUCCO version with a low specific weight which allows the grouted supports not to vary.
TECHNICAL DATA
Specific weight: 1700 ± 20 g/ml;
V.O.C.: 45 ± 2 g/l;
Viscosity: 1600 ± 200 cP;
Consistency: 1100 ± 200 cP;
Color: Ice white.
STORAGE
Store the packages tightly closed and in a cool (temperature below 25°C) and ventilated place for a maximum of 12 months starting from the production date highlighted on the jar. Avoid direct exposure to sunlight.
APPLICATION
Make sure that the surfaces to be grouted are perfectly dry and clean. In case of application on bare sheet metal, sand it with P 80 and P 150 abrasive paper.
Using clean tools, remove the quantity to use from the jar, adding 1 - 3 grams of hardener for every 100 grams of product.
Mix this quantity by amalgamating the two components well.
Apply the stucco on the surface to be worked on, keeping in mind that the product can be sanded (grit P 80 – P 120 dry) after approximately 30 - 40 minutes; hardening times can be altered depending on the ambient temperature: they are shortened with temperatures above 25 °C and longer with lower temperatures.
Do not put catalyzed and/or unused stucco back into the can to prevent the entire contents of the can from deteriorating.
Close the jar after use to prevent the product from hardening upon contact with air.